very impressive. but for the setup is a very good number... maybe too good i guess. how many hp could be gained on a decent ECU remap? Also, how much (€) would it be for a decent aftermarket Camshaft? Did i understood well?The Cam in that project is altered? Thank you I've done some researche, cam ...

yes, that's the guy H4WK and movie is from january '09 and it's before he got this higher compresion headgasket, custom cam, camwheel skunk2 and apexi, 153 he get after tune this setup

About his mods... I belive he don't tell about all

I will try to verb him to this forum

impressive but are you sure this is a d14? i am saying that because it is very strange to have 160NM of torque and 153hp with 7300rpms rev limiter! Are you sure you are aware of all the engine mods? :roll: first I didn't belive in this article also... but this guy become well known in Poland with h...

PO6 and P28 are 5g. ('92-'95) ECUs there was no oem immo then... so there is no problem. I ride with PO6 with oem d15b7 fuelmaps now, propably Dodo also has PO6 with vtec added... if he didn't change it since he wrote his OBD1 manual ;) . P28 is for vtec so you can use it after minime, also becouse ...

The head should actually be identical, it is the cam that probably makes all the diff. Curious how this cam actually runs... any dyno's of those? actully it's not easy to find and prove becouse everybody have few more mods at thesame time... But here you have some nice project- I try to translate b...

saxophonias wrote:Are these obd1 ecus?

yes

PO6 goes with d15b7 engine OBD1 mpfi non vtec
P28 goes with d16z6 engine OBD1 vtec

P28 is most wanted Honda ECU, can be adapded to all B-series engine, becouse it's easy do remap and and some new maps.

PO6 and P28 are almost the same, but PO6 don't have vtec. Here are some "how to" add vtec to PO6 1720 board http://wikitest.pgmfi.org/twiki/bin/view.pl/Library/02D01720-1500 http://www.xenocron.com/install/1720.htm 11f0 board http://wikitest.pgmfi.org/twiki/bin/view.pl/Library/02D011F0-150...

Dodo some day I asked you if it's good idea to put head from d16y7 on d14 block, and you posted that it could be beter idea to swap only cams. I discussed about this on my local forum, and now there are some project with this two type of setup. So as I know from those forum is that d16y7 cams and he...

How ever... you are official guru of d14 mods, and "the one who put vtec on d14"