D14 connecting rod bearings part numbers : KOLBENSCHMIDT CB-2204GP STD HONDA 13022-PE0-S10 HONDA 13022-PE0-S20 HONDA 13211-PE0-003 FEDERAL Mogul 4-1510 CP STD ACL 4B1930 STD Overal view D14 aftermarket bearings ACL Duraglide Conrod Bearing Set : STD,0.25,0.50 : 4B1930 ACL ALuglide Main Bearing Set :...

Some potentional pistons we can use in the D14 engine Stock D14a4 piston Diameter : 75mm Compression height: 29.5mm Dish/dome : -5.4cc ~ -1.8mm deep Pin Diameter: 19mm x 57mm Nissan GA15DE/DS 16valve (Nissan Sunny /primera/100NX / 1993’ - …) Stock Diameter : 76mm Compression height : 29.5mm Dish : -...

Yes unfortnatly they also don't fit , big end width is just too small
Honda really did make a connecting that no other brand uses .Impossible to find any that fits ,i did find some with the same 40mm big end diameter but most of the time the big end width is too small.

Great! :mrgreen: I only hope those are cheaper then oem honda pistons.Mahle is also a good brand ,i believe porsche has mahle pistons too.Mahle pistons should be available from local dealers .Strange is i checked with other part numbers of the P3Y (D14a4) pistons and those arent listed also pistons ...

stmark wrote:Thank you hondaNickx,
It's hard to find this pistons exept from honda.

The PHXG piston fit without milling ??

Yes compression height is the same , it only has a smaller dish in the pistons which gives you more compression.

Nope i've searched the whole internet for aftermarket oem pistons can't find any. The only ones i've found are PG6 pistons and those don't fit unless you mill them 0.5mm down. P29 do fit but will sit lower in the engine. Try finding a low milage D14z2 block or any from a 99-00 civic D14 and take tho...

Ow yes you're right ,didn't noticed that before :) . I've looked into the Clevite /mahle bearings and those would be the same as ACL Duraglide or slightly better.Not like acl race bearings. So the ACL Duraglide conrod bearings and Mahle/clevite 77 main bearings would be a great combo to replace oem ...

I found Tri Metal main bearings for D14 crank, it's a MAHLE CLEVITE MS-1806AL, (Clevite for US country) Material : TM-1 :mrgreen: The main's bearings are made for Honda civic 74.00 mm Bore DX/CRX D15B2/7 for the US market. ONLY THE MAIN BEARINGS FOR D14 ! THE D15B2/7 RODS BEARINGS DOESN'T FIT ON D1...

Great Info STMark! Law has been using the acl D13 bearings in his rebuilded engine for some time now. They fit perfect .We should ask if ACL could produce these bearings in their race bearings .Those are much better then the aluglide.It's also great to know TDC makes these bearings ,maybe we can fin...

I've searched the entire internet ,gone true a lot of catalogs of bike and car connecting rods and the closest rod i've found that fits the D14 engine is one of the Nissan sentra 1982-1988 1.5L /1.6L engines. The E15ET and E16 rods and E15 rods . Length (CD): 137.5mm Big end bore: 43mm Pin size: 19m...