www.dodo-upgrades.nl

I once again look OBD2B. Thanks, I'll think about it.

about WIDEBAND LAMBDA, what is it? there are articles on the setup? or shared your experience))))

I will need to enter the service mode (close contacts), and replace STOCK HONDA LAMBDA in the exhaust manifold on WIDEBAND LABDA?

I see that WIDEBAND LAMBDA consists of 2 parts. display and the probe labda (c 2 wires name) I need both? or is it sufficient to connect the display with any O2 probe labda?

about setting fuel cards, I think I could use someone else's settings as theoretically base. take any firmware for CROME D16Z6 and see what dose of fuel \ air they used.

afaik wideband lambda probe is for live tunning (to tune your car while its moving). It will do the basic function of Lambda Probe but the values are shown in dials to allow you to enrich or not the fuel mixture etc...

Internet, I saw projects where the ECU combines the two, perhaps this is my case!
1 ECU STOCK will be responsible for automatic,
2nd ECU for sensors and fuel cards + V-tec, and I think that he might not be for AT. would find it ....
on PGMFI.org was so, but has not yet been found.