[LOOK IT] STEP 3. Configure Fuel card

[ilya]

OK! i have VTEC and chiped ECU. after 2 year, im happy

next step - it's configure fuel card... tommorow i send email to Russian "Famous" tuining group for made this operation.

they answer:
"we configure AT only with UICHIP and our ECU. PRICE - 650$"....

I think it litle expensive, and i already have ECU. i will find methodology for setup it.

what i need except O2 WideBand?
and what is it? it's common O2Sensor with monitor? or O2 sensor - special?

[BETEK]

The AEM Wideband is the best out there.
http://www.aemelectronics.com/wideband- ... ge-kit-745

[ilya]

experimental firmware, is based on D16Z6 P28 AT for D14A4 with VTEC
-VTEC 4560
-rev im 6816
-speed limiter 105mph ~ 168kmh

-No knock sensor
-No oxygen sensor heater
http://www.ej9.ru/data/bin/EJ9_p28_0611.bin

firmware by 1net , is based on D16Z6 for D14A4 MT (i use it in AT)
i recomended it for start after swap to OBD1.

-No knock sensor
-No oxygen sensor heater
-rev limit ~ 7200

http://www.ej9.ru/data/bin/d14vt_final.bin

[Dodo Bizar]

On a sidenote: if you can, increase revs, 7200~7500 engine can cope with that normally. Though probably the AT shifts too soon to have any effect?

[ilya]

I reduced the REV, because I'm afraid of the big turns. never did not go to such speeds, I'm afraid of engine failure.
+ In a week I'll change the piston rings, and REV still undervalued, just in case. precautions. I will experiment later with REV.

Now I have found the approximate setting cards for 1.4 AT With p28.
decreased consumption of gasoline) PGMFI cool!
+ Add VTEC
+ At low speed once the car started to go better!

I think our job is close to the machines 1.5.
not VTEC-E, a real aggressive VTEC!


later i upload it, in august i want make dynotest.

[Dodo Bizar]

Yes you are right about keeping revs low with the current situation of the engine. Looking forward to your dyno!

[ilya]

in august Man) i waiting it too)

[ilya]

anyone else is doing? how many people who have replaced the OBD1?

[mynameisowen]

So let me get this right, you are making your own map for your ECU?? What software are you using?

[ilya]

CROME, just CROME and software for programmer PicProg+ for flashing memory. now i write my own editor for LINUX =) because CROME didn't work here((