few questions: from d16z6 to d14

[d-series-sol]

Guys I think this is the right section to ask but here it goes as my del sol is obd1 & vtec doing the mini me is going to be lot easier but as per my introduction thread that won't be happening for a while as I need to save up to get it the head rebuilt and all associated bits.

Going to drop a d14a4 in and run it with the usual bolt on mods with a tune until I can complete the mini me, what I need to know is with the wiring side the z6 loom will fit the engine fine (stuff like starter and alternator & inlet sensors ok) but what about the dizzy can I keep using the d14 one or would the plug on the loom need replugging? can not think of anything else at the moment in terms of wiring that needs to be done?

[Dodo Bizar]

Depends on the ECU you want to work with... I suppose you keep OBD1 ECU around all the time? Then get OBD1 dizzy on the D14 (and safe the trouble of re-plugging).

[d-series-sol]

ill be keeping the p28 Joris ah cool looks like a nice easy conversion then