ej9 interieur problems

Any issues? Discuss them here
Post Reply
bubba ej9
Posts: 5
Joined: Thu Aug 01, 2013 11:00 am

ej9 interieur problems

Post by bubba ej9 »

hello

i have a face lift ej9 d14z2
now i swapped the d15z6 from a ek3 pre face lift
bur now i dont have a rmp gauge km gauge fuel and water also if i put it in reverse the lights dont work

i was looking at the kabels and i see that the socket is te same but the kabels are put in difrend
some have pin out.... link for a site ....can you buy harnas....

User avatar
saxophonias
Posts: 2590
Joined: Fri Jul 03, 2009 6:03 am

Re: ej9 interieur problems

Post by saxophonias »

it seems you have messed with the wiring. Do you have the pin outs and the electic diagram of the car?

bubba ej9
Posts: 5
Joined: Thu Aug 01, 2013 11:00 am

Re: ej9 interieur problems

Post by bubba ej9 »

its the obda2 i just see on your pin outs
but listing the car is complete stock ej9 with d14z2 wiring inside en the engine and loom are d15z6
i didin't cut anything all is just connected
but now i see that the connector off interieur are the same but the cables are not
if you want i make foto and than you can see
car is honda civic ej9 d14z2
engine d15z6 and engine loom d15z6 with the oem ecu p2y
i removed the immobileizer off the p2y then my car start's but my rmp km fuel and water gauge dont word
my reverse dont work vtec dont work

Post Reply